Key Maintenance Points for 520 Non-O-Ring Chains
Cleaning: Perform as needed, avoiding excessive frequency.
Frequency: More isn't always better. For dry, clean road commutes, inspect and clean every 500-800 km. For rainy, muddy, or dusty conditions, clean every 200-300 km or after each ride.
Park and support the rear wheel with a kickstand.
First, use a stiff brush to remove large dirt particles from the surface, preventing grime from embedding in the chain links.
Apply a specialized chain cleaner evenly over the chain links and let it sit for 3-5 minutes.
Using a soft brush, carefully scrub the inner sides of the chain links and roller gaps in the direction of chain movement. Do not forcefully pull the chain.
After cleaning, thoroughly dry the chain with a clean cloth, ensuring no moisture remains, as this can cause rust.
Lubrication: The Critical Step-Choose the Right Oil
Oil Selection: Since there are no O-rings to seal in grease, you must use a specialized wet chain oil. This oil has strong adhesion, clings better to the chain surface, and provides long-lasting lubrication. Dry chain oil or regular engine oil is not recommended, as they can be easily flung off by centrifugal force or attract excessive dust.
Slowly rotate the rear wheel while evenly spraying the chain oil onto the inner side of each chain link (the side in contact with the sprocket).
Spray once every half rotation to ensure every link is covered.
After lubrication, let the chain rest for 10-15 minutes to allow the oil to fully penetrate.
Be sure to wipe off any excess oil from the chain surface with a dry cloth. This is a crucial step to prevent dust and sand particles from adhering and forming abrasive paste.
Tension: Regularly check chain tension. Pinch the middle section of the chain and move it up and down; the movement should be between 20-30 mm. If it exceeds this range, calibrate by adjusting the chain tensioner on the rear wheel axle. Ensure the left and right tensioner settings are identical to prevent uneven chain wear.
Wear and Rust: Inspect the chain surface for visible rust. If present, gently sand it off with fine-grit sandpaper, then thoroughly clean and re-lubricate the chain. If significant chain elongation is detected (where standard tension cannot be achieved even after adjustment) or if chain links become stiff or jam, replace the chain immediately.
